Also put back the little orange plastic thing that includes the on/off button. While I was at it, I wiped the other metal circles near the volume metal circles. I just used on alcohol pad like you would use if giving an injection. Once the volume buttons are out turn them over and clean them with alcohol. Insert the point with out the slit and then you can decrease the length of the rectangle at the slit end. If you accidentally remove it, there is a slight split at one end. Incidentally, the hinge is just a point of plastic at either end of the rectangle. One side has the buttons everybody sees and uses right out in the open and the other side has the rubber buttons underneath the hinged cover. Remember, the remote has buttons on both sides. Underneath the motherboard is a small rectangle containing the up and down buttons in a plastic rectangle also having metal electricity-conducting circles. BTW you must also remove the motherboard with a Phillips screw. When you push a rubber button, it pushes on the plastic which pushes the metal against contacts in the mother board. The rubber sheet interfaces with a light grey flexible plastic rectangle with many metal circles embedded in it that conduct electricity. On the back side, the buttons are rubber indentations on a rectangular rubber sheet. None of the buttons are real buttons with switches. Watch out for a small orange plastic structure about 2" long which has two buttons on it including the on/off button. you must disassemble everything and there are a lot of parts including the motherboard with the infrared lightbulb attached as well as two battery contacts. Take note of how everything is laid out inside. After that, one can continue working it apart or it might even easily open at that point. First, one must open the battery compartment, take out the batteries and then unscrew a small Phillips screw. One must be careful not to continue that action where the battery compartment is. I would stick the round end of the knife in the edge and twist the knife to separate the remote. I used a kitchen knife for spreading butter without a sharp edge to pry it open. John Hedstad's comment was very helpful and resulted in the successful restoration of my volume controls on the remote for my Denon model 1910 AVR. We tell you how to program remotes in our guide to remotes. Start with the receiver and work your way through programming each component that isn't working. They may be dead.Ĭheck to make sure the remote is programmed properly, which basically means you reprogram it to work with your receiver, TV and any other components. If they're in correctly and you still don't get power, try replacing them. Check to make sure they are in the right way, with the metal ends making good connections with the metal in the remote. When you press a mode button, does it light up? If not, you may be out of juice. Your remote should work properly.Ĭheck the batteries. Press the SAT mode button at the top to unlock it. When a button is pressed for longer than three minutes, the remote goes into battery-saving mode. Clear any dust or debris that may be covering the eye. Make sure you have a clear path between the remote and the infrared eye on your equipment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |